Compact Industrial Mini-Pleat Filter

Clean Air Matrix

RoboVent engineers are experts in every category of air filtration and ventilation. The four categories below represent the major options for treating your contaminated air. RoboVent has designed solutions for each of these categories and has manufactured air filtration systems of unrivaled quality.

For more information about these categories, see Indoor Air Quality 101.

Ambient_Filtration

Large blowers and air filtration equipment draw contaminated air from the plant (typically at the ceiling level), filter it and return it to the plant. This is a proven solution in plants welding large parts with overhead cranes. It reduces the haze in the air, resulting in a cleaner working environment, with no negative pressure or heat loss.

SourceCapture_Filtration

Air in the immediate area of the welding activity is captured in a hood system, then filtered and returned to the plant. This is the best solution whenever possible. It allows for a more flexible system and removes the smoke directly from the operator's breathing zone. There are many types of source capture, including overhead hoods, crossflow hoods, fume arms and fume guns, some of which work better than others.

Ambient_Exhaust

Large exhaust fans draw contaminated air from the plant and exhaust it directly into the environment, typically through the roof or walls. This is a traditional method and often results in negative air pressure. Also, it is very difficult to climate-control your plant and the system may not work well in the winter.

SourceCapture_Exhaust
Air in the immediate area of the welding activity is captured in a hood, sent through ductwork, and exhausted directly into the environment. This is a lower capital cost alternative to filtration, but tends to result in high operating costs and large, unsightly ducting systems that work less efficiently with modifications. It also results in negative pressure problems.

These filters are used in HVAC installations where highest degree of air filtration is required. The compact design, larger surface area and low initial resistance make these filters an alternative to ordinary bag filters & box type filters of similar efficiencies.

This type of filter is also available with very high burst resistance, low pressure drop and high dust holding capacity for extreme operating conditions. The Synthetic mini pleat filter is designed for use where extended filter life is required. The frame is injection molded polypropylene with polypropylene pleat separators and V shape construction. 100% non-shedding, gradient density polypropylene fibers with MERV ratings of 12-16.

Types of Mini-Pleat Filters We Offer:

  • HC-Mini
  • HC-X Mini

 

Get a Filter Quote